Medium Duty Wide Spreader
The Smith Medium Duty Wide Spreader was designed for your medium duty range of trucks. Constructed of 304 stainless-steel for lasting durability, designed with Independent Contractors and Municipalities in mind. The customer that is seeking that bit of extra room will find this, the go-to spreader. Capacities ranging from 6 – 10.5 yards anything can be covered with these units. Our standard units are 52” in height and 83” wide, length of unit will vary from 8’ to 12’ depending on capacity needs. Available in Dual Electric or Dual Hydraulic.
- All T304 stainless steel construction.
- 11 GA hopper – minimum 3 side gussets.
- Inverted “vee”.
- On/Off switch.
- Replaceable slider bed.
- 16″ Wide conveyor frame.
- 15″ Wide 662 pintle conveyor chain with 3/16 x 1 crossbars.
- Dual electric drive or hydraulic drive.
- 8 tooth cast iron keyed sprockets, 1-1/4″ drive & idler shafts.
- Externally mounted take up style idler bearings with grease lines
- 14 gauge flip up discharge chute – 14″ poly 6 vane spinner disc – 3 externally adjustable flappers.
- Install wiring kit.
ACCESSORIES & OPTIONS:
- Dual Speed Control.
- 6″ or 12” top bolt on top extension – all models.
- Door – screw jack operated.
- Stainless Steel “clip over” tie down brackets (4).
- Spill Shield – 12″ UP 12″ OUT (for front or rear).
- Custom S/S cab shield.
- S/S light box (6 x 6 x 3) 4 ½” hole.
- S/S light bar – Back of unit.
- Ladders – 2 or 3 steps.
- S/S or M/S latch bars, specify round stock size.
- S/S catwalks for frame-mounted units.